Beginner's Guide to Installing a New Shower Unit

Call Today

We've found this great article on Simple ways to Install a Shower Cubicle on Your Own below on the internet and concluded it made sense to write about it with you on my blog.

An effective shower setup needs mindful planning as well as a lot of job. In most cases, you will certainly need to do 3 types of jobs: framing walls, installing the plumbing, and also finishing wall surfaces.

Preparation

To start with, you should pick the kind of shower that you desire to install. It is very important to determine whether the picked shower can coping with particular systems and can control a safe level of water via the boiler. A lot of shower units nowadays are developed to be adaptable to different water pressures (such as saved warm water and also cold mains).
It is additionally important to take into consideration the water stress and the planning of the piping and drain for the shower

Various Sorts Of Shower Units

Push-on Mixer: The hose as well as spray parts of the push-on mixer shower system can be attached to the bathroom faucet as per your requirement, as well as the water temperature level can be readjusted using the taps. Push-on mixers are cheap and incredibly easy to set up. Nonetheless, although the tube link is simple, it is easily removed. Furthermore, it is troublesome to change the temperature.

Bath/Shower Mixer: The pipe and also spray of this sort of shower are incorporated with a bathroom mixer faucet, and also the temperature can be changed with the bath taps. It is a very low-cost choice as well as no additional plumbing is involved. However, the bath/shower mixers additionally suffer from inconvenient temperature level control alternatives.

Guidebook Mixer: The pipe as well as spray of a manual mixer shower unit are a part of the wall device and also the cold and hot water materials are connected to a single valve The temperature and also stress of the water are managed with either one or a range of knobs (in more expensive showers). Although temperature level control is much easier in hands-on mixer kinds, they are a lot more pricey than the formerly pointed out mixers. They likewise call for added plumbing of cold and hot water supply pipelines.

Thermostatic Mixer: The pipe and spray of this shower kind belong of the wall surface system as well as the hot and cold water materials are attached to a single valve right here as well. It is total with an integrated stabiliser to self-adjust the water temperature level and also to prevent it from coming to be as well hot. One of the greatest benefits of a thermostatic mixer shower type consists of practical temperature level control. Nevertheless, it is the most expensive of the different mixer options.

Power Shower: A power shower is a solitary unit containing an effective electric pump that is capable of changing both the water stress and temperature. This type of shower can be fitted if there is supply of water from a cold water cistern and also a warm water cylinder. A power shower makes the adjustment of both stress and temperature very easy. On the other hand, it disagrees for water heated straight by the shower or where the water is supplied by a combination central heating boiler under mains pressure.

Electric Shower: An electric shower is plumbed into a keys cold water supply as well as it warms the water electrically. It is necessary to keep in mind that for this shower type to be installed, the mains pressure requires to be a minimum of 0.7 kg/sq centimeters (10lb/sq in). The system enables the temperature and stress to be readjusted via a knob. Versions with temperature level stabilisers are better as they stay untouched by various other faucets in other places in use within the family. A significant downside of electric showers is that the control knob only enables the choice of high temperatures at much less pressure, or lower temperature levels at a better stress. This is problematic in the winter when the spray is commonly weak and also the keys water is cooler. Nevertheless, this trouble is taken on in some versions which are readily available with a winter/summer setup.

Method

Depending on the sort of shower you wish to set up, the shower head should either be suited order to avoid its contact with the water in the bathroom below or the base tray, or it should have a check shutoff.
Before starting, it is a good idea to note the placements of the shower head and control, as well as to intend the pipe-work included. In addition, the drain system to get rid of the waste water will certainly need to be intended. Both placements of the cord path and the shower switch will certainly additionally require to be taken into consideration if an immediate or electrical shower unit is being set up.
Make use of the guideline overview offered with the shower system to fit the shower control.Before suitable the pipelines that will supply the water to the shower system, it is necessary to remove the water. In order to protect the pipelines, they ought to be offered a waterproof covering as well as additionally fitted with isolating valves. The pipes can after that be buried into the wall surface as well as smudged over to neaten the general look.
Fit the base tray, shower head, and also installations.
Connect the major shower control to the pipelines that will be providing the water (This may require a women screw thread adapter).
Reconnect the water supply as well as test the pipelines for any kind of leaks, as some may need tightening.
If you are installing an electrical shower, bear in mind to turn off the electrical energy supply before making any kind of electrical links. When these connections have been made (there need to be support within the instruction manual), the power supply can be switched over back on.

Adjusting Water Stress to Suit Your Shower

The cold water storage tank can be lifted to a better height (in some cases as little as 150mm (6inches)) by installation a strong wooden assistance underneath it - possibly composed of struts and blockboards. If you pick this choice, the major and circulation pipelines will additionally have to be elevated to fulfill the new elevation of the storage tank.
Additionally, a booster pump (a solitary pump or a dual/twin pump) can be fitted. Whichever kind is picked, it must be linked right into the power supply in order to operate.

Piping as well as Water drainage

It is best to use 15mm diameter supply pipelines, and also make the runs to the shower as short and straight as feasible so regarding maintain maximum pressure and also reduce heat loss. Furthermore, by minimising using joints for pipe corners, you can reduce the resistance in the circulation of the water supply. You can achieve this by bending the pipes rather.

Many Typical Errors

Going against or ignoring local code limitations.

Utilizing pipelines that are too small.

Attaching copper to galvanized without utilizing a brass or dielectric fitting between the two.

Not utilizing tape or pipe compound at threaded joints.

Uneven your components when mounting them.

Not installing an air gap filling for fixtures.

Reducing supply stub outs also brief to mount the shutoff valves onto after the completed wall is in place.

Not correctly lining up tubing into installations or quit shutoffs. (Forcing the nut onto the compression ring at an angle when the tubing goes to an angle will certainly create a leakage.).

When transforming the water back on in your home, always run the outdoors hose shutoff or flush your bathrooms to bleed dirt and air from the lines. This debris can create issues in your sink taps and also other plumbing trim.

Most Popular Shower Enclosure Options to Upgrade Your Bathroom

Frameless Shower Enclosures

Switching to a frameless shower enclosure can instantly add a modern feel to your bathroom. This type of shower enclosure eliminates the visual obstruction of frames, providing a seamless flow using fully customisable glass.

Since they are fully customisable, it fits all sizes and shapes of your bathroom space. You can also design it in a way suitable for an expansive spa shower.

In-line Shower Options

Another popular shower enclosure option you can use to upgrade your bathroom is an in-line shower. This type of shower installs a shower glass in-line with an adjacent wall, keeping water within the shower area.

You can have two options for in-line showers: hinged doors and sliding doors. An in-line shower with hinged doors allows you to have one glass shower door mounted on one side and open the door outwards. Meanwhile, in-line showers with sliding doors will enable you to save space but are more expensive.

Semi-Frameless Shower Enclosures

The semi-frameless shower enclosure is also an excellent shower enclosure option as it reduces the possibility of mould. Since the glass door is frameless, there’s no way soap and water will be stuck on it. But to ensure that there’s no way for mould to flourish in your bathroom, choose frameless shower enclosures instead.

Semi-frameless shower enclosures are the ideal choice if you adore the design of frameless showers but would prefer a more affordable solution. These types of shower enclosures have a range of options available by the glass manufacturing process in accordance with various height specifications.

You can also customise this type of shower enclosure. However, your options might be limited because of the standard sizes and heights.

Glass Block Shower Enclosure

If you don’t want a bathroom door and walk-in glass shower enclosures are not an option either, a glass block shower enclosure is for you. Glass blocks will allow your bathroom to access maximum daylight while having the privacy it offers. Also, glass block enclosures might require a bit more effort to clean than other enclosures, but they are durable and versatile options.

You can also be creative when using glass blocks for your bathroom. Since this type of shower enclosure is made of small glass blocks, you can easily create a unique shower enclosure shape. There are many options for thickness, styles, and colours, too.

Final Thoughts

Upgrading your bathroom with a new shower enclosure is a great way to add value to your home. Not only will it appear nice, but it will also be more functional and efficient. When choosing a shower enclosure, pick one that fits the style of your bathroom and your budget. It’s also paramount to take note of the pros and cons of each type before installation to ensure you don’t miss anything important.

https://gharpedia.com/blog/shower-enclosure-to-upgrade-bathroom/

Do you appreciate more info about How to Build a Shower Enclosure for Your DIY Bathroom? Post a comment directly below. We'd be interested to find out your thinking about this post. Hoping to see you back again in the future. Sharing is good. You never know, you could be helping someone out. I enjoy reading our article about How to Install a Direct-to-Stud Shower Enclosure.

Instant Quote